KD1MU 12.8 Volt 20AH LiFePo Battery

Description

These are the technical details from the website:

• Quality LiFePP4 Battery for on-the-air portable operation,
• Low Noise. Designed for HF Radio.
• XT60 power connection with 12 AWG Power Pole power adapter (output only)
• 6 cm 10 AWG power output cable from the battery to the XT60 connector.
• Nominal 12.8 volts, 20AH capacity (256 WH)
• 3000 charging cycles (discharging to 90%)
• 40amp Power Plate capable of
• 40amp continuous current
• Designed to provide 20amp with 40am peaks.
• Weighs 1.8 kilos / 4 lbs.
• 5mm x 2.1mm charging connector female or male charging cable and adapter.
• Charge with a Low Noise 14.6 Volt, 5A charger.
• Battery covering is water repellent, but not waterproof.
• The Battery does not require any maintenance except for charging.
• Use a charger designed for LiFePO4 batteries only.
• Operating temperature: Between -20°C to 60°C (-4°F to 140°F)
• The Battery BMS will protect the battery by cutting off power in the following conditions:
  1.  Overheat
  2.  Temperatures below operating conditions.
  3.  Short circuit
  4. . Overcharging (above 14.3 volts)
  5. . Low voltage (under 9.2 volts)

• When using a solar charger, make sure your controller unit is designed for LiFePO4 batteries.
• The solar controller must provide 14.6 volts DC output.
• Battery may be in service and charged at the same time.
• Dimensions: 165 X 95 X 75 mm (6.5 X 3.75 X 3 inches)